British Standards Institution

Source:: ISO
Committee:: ISE/101/1 - Uniaxial and Ductility Testing
Categories:: Information management | Standardization. General rules | Manufacturing | Metallurgy | Metal testing | Metal testing. Mechanical

Scope

This document provides specifications for testing miniaturised metallic test pieces where not enough material is available for test pieces according to ISO 6892-1 [1].

The guidelines in this document are not intended to replace the requirements of the standard method described in ISO 6892-1.

This document refers to conventionally manufactured materials.

NOTE 1 Additional information regarding testing of additively manufactured materials are given in ISO/ASTM 52909 [2].

NOTE 2 Further information on the performance of miniaturised test pieces in tensile testing and the comparability of respective results is available in [3-9].

Purpose

This International Standard provides guidelines for testing miniaturised metallic test pieces and can be applied in cases where not enough material is available for test pieces according 6892-1.

Miniaturised test pieces can e.g. be used in the following cases:

— Verification of component specifications and optimisation of the production of components

— Validation of FE-forming simulations

— Determination of input data for crash and service life calculation

— Characterisation of local properties e. g. properties in the vicinity of welds

— Evaluation of cases of damage (failure analysis)

— Product development

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

17/10/2023

Proposal end date:

11/11/2023

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

ISO/NP TS 6892-5 Metallic materials — Tensile testing — Part 5: Part 5: Specification for testing miniaturised test pieces

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error