British Standards Institution

Source:: ISO
Committee:: NCE/9 - Nuclear Installations, Processes & Technologies
Categories:: Information management | Standardization. General rules | Engineering | Energy and heat transfer engineering | Nuclear energy engineering | Nuclear energy. General | Fissile materials and nuclear fuel technology

Scope

This method applies to the preparation and validation of the spikes used for the measurement of the concentration of uranium and/or plutonium in input solutions of irradiated Magnox and light water reactor fuels (boiling water reactor or pressurized water reactor), in final products at spent-fuel reprocessing plants and in feed and products of MOX and uranium fuel fabrication by isotope dilution mass spectrometry (IDMS).

Purpose

Isotope Dilution mass spectrometry (IDMS) is used to analyse plutonium and uranium for safeguards of nuclear fuel materials. To measure plutonium and uranium by IDMS, reference materials which called spikes are needed. Although the spike preparation method is described as Annex in ISO 8299, it is very limited and it has been more than 20 years since it was created. Therefore, this document, which is replaced ISO 8299 Annex A, have been created as an independent ISO standard for spike preparation and have include latest technique of spike preparation.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

24/01/2022

Proposal end date:

20/02/2022

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

ISO/TC 85/SC 5 - ISO/NP 6863 Preparation of Plutonium and Uranium spikes for Isotope Dilution Mass Spectrometry (IDMS)

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error