British Standards Institution

Source:: ISO
Committee:: STI/36 - Vitreous enamel coatings
Categories:: Information management | Standardization. General rules | Engineering | Manufacturing engineering | Surface treatment and coating | Enamels

Scope

This document specifies the basic conditions concerning the method for determining the resistance of vitreous and porcelain enamelled articles to heat.

The method specified is applicable to vitreous and porcelain enamelled articles that will, in service, be subjected to high temperature, for example to some cooker components, exhaust pipe silencers, gas heating chimneys and flue pipes.

Purpose

Purpose: Clearer definition of the given requirements

Justification: During the systematic review it was seen that the standard was too unclear (vague) and needed some clarification.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

16/04/2021

Proposal end date:

08/06/2021

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

ISO/TC 107 N 2454, ISO/NP 4530 Vitreous and porcelain enamelled manufactured articles -- Determination of resistance to heat

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error