If you have difficulty in submitting comments on draft standards you can use a commenting template and email it to admin.start@bsigroup.com. The commenting template can be found here.
This document applies to cold rolled uncoated and electrolytically zinc or zinc-nickel coated low carbon steel products, steel products with high yield strength steel, low carbon steel flat products for vitreous enamelling, sheet and strip for welded gas cylinders and multiphase steel flat products for cold forming with a minimum thickness of 0,20 mm and, unless otherwise agreed at the time of ordering, less than or equal to 3 mm thick, delivered in sheet, wide strip , wide strip or sheet. The concerned standards are slit wide strip or cut lengths obtained from EN 10130 [1], 10268:2006+A1 [4], EN 10209 [5] and cold rolled products in EN 10152 [2], EN 10120 [6] and EN 10271 [3], EN 10338 [7].
The tolerances of this document can also be used for deliveries of non-standardized products.
It also applies to other cold rolled steel flat products with metallic coatings applied in other continuous processes, e.g. jet vapour deposition, except for hot-dip coating.
Required form fields are indicated by an asterisk (*) character.
You are now following this standard. Weekly digest emails will be sent to update you on the following activities:
You can manage your follow preferences from your Account. Please check your mailbox junk folder if you don't receive the weekly email.
You have successfully unsubscribed from weekly updates for this standard.
Comment by: