British Standards Institution

Source:: ISO
Committee:: STI/21 - Paint systems and surface preparation for metallic substrates
Categories:: Surface preparation
Comment period start date:: 09/10/2024
Comment period end date:: 02/12/2024
Number of comments:: 0

Comment by:

2nd Dec

Scope

WARNING — Equipment, materials and abrasives used for surface preparation can be hazardous. It is important to ensure that adequate instructions are given and that all required precautions are exercised.

This document describes a classification of non-metallic blast-cleaning abrasives for the preparation of steel substrates before application of paints and related products.

It specifies the characteristics which are required for the complete designation of such abrasives.

This document applies to abrasives supplied in the "new" or unused condition only. It does not apply to abrasives either during or after use.

NOTE Although this document has been developed specifically to meet requirements for preparation of steelwork, the properties specified will generally be appropriate for use when preparing other material surfaces, or components, using blast-cleaning techniques. These techniques are described in ISO 8504-2[1].

Read draft and comment

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

14/06/2024

3. Public Comments

Public Comments start date:

09/10/2024

Public Comments end date:

02/12/2024

Learn more about the standards development process

Standards Development

BS EN ISO 11126-1 ISO 11126-1 Preparation of steel substrates before application of paints and related products. Specifications for non-metallic blast-cleaning abrasives. Part 1: General introduction and classification

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error