We use cookies to give you the best experience and to help improve our website

Find out what cookies we use and how to disable them

BS ISO 12051 ISO 12051 Plastics piping systems for water supply and drainage and sewerage under pressure. modified poly(vinyl chloride)(PVC-M) pipe

Source:
ISO
Committee:
PRI/88 - Plastics piping systems
Categories:
Pipelines. Plastics | Water supply | External water conveyance systems | External sewage systems
Comment period start date:
Comment period end date:
Number of comments:
0

Comment by:

Scope

This standard specifies requirements for pipe and integral joints of higher level of impact resistant PVC-M for the conveyance of water and waste water under pressure. The pipes are intended for installation below and above ground where they are not exposed to direct sunlight.

It also specifies the test parameters for the test methods in this standard.

It is applicable to extruded PVC-M pipes without a socket and pipes with a socket (integral or not), intended to be used for the following:

a) water mains and services buried in the ground;

b) conveyance of water above ground for both outside and inside buildings;

c) buried and above-ground drainage and sewerage under pressure.

It is applicable to piping systems intended for the supply of water under pressure up to and including 25 °C (cold water) intended for human consumption and for general purposes as well as for waste water under pressure.

This standard specifies pipes for the conveyance of water and waste water up to and including 45 °C. For temperatures between 25 °C and 45 °C, Figure A.1 applies.

NOTE 1 The producer and the end-user can come to agreement on the possibilities of use for temperatures above 45 °C on a case-by-case basis

This standard specifies a range of pipe sizes and pressure classes, and gives requirements concerning colours.

NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.

Read draft and comment

Comment on proposal

Required form fields are indicated by an asterisk (*) character.


Please email further comments to: debbie.stead@bsigroup.com

Follow standard

You are now following this standard. Weekly digest emails will be sent to update you on the following activities:

You can manage your follow preferences from your Account. Please check your mailbox junk folder if you don't receive the weekly email.

Unfollow standard

You have successfully unsubscribed from weekly updates for this standard.

Error