British Standards Institution

Source:: ISO
Committee:: PRI/22 - Rubber - raw materials (including latex) including testing and analysis
Categories:: Rubber
Number of comments:: 0

Scope

This document specifies a method for determining the indentation hardness (Shore hardness) of vulcanized or thermoplastic rubber using durometers with the following scales:—the A scale for rubbers in the normal-hardness range;—the D scale for rubbers in the high-hardness range;—the AO scale for rubbers in the low-hardness range and for cellular rubbers;—the AM scale for thin rubber test pieces in the normal-hardness range.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

24/01/2017

3. Public Comments

Public Comments start date:

28/03/2017

Public Comments end date:

19/05/2017

Learn more about the standards development process

Standards Development

BS ISO 7619-1 Rubber, vulcanized or thermoplastic -- Determination of indentation hardness. Part 1: Durometer method (Shore hardness)

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error