British Standards Institution

Source:: CENELEC
Committee:: PEL/13 - Electricity Meters
Categories:: Information management | Standardization. General rules
Comment period start date:: 03/02/2025
Comment period end date:: 26/02/2025

Comment by:

26th Feb

Scope

This document defines the metrology requirements for measuring systems that measure transferred energy between stationary conductive direct-current and alternating-current electric vehicle supply equipment and electric vehicles. This document contains requirements as well as criteria for testing measuring systems. This document specifies in addition requirements such as for: — the measurement of the duration of the energy transfer session; — energy transfer at different tariffs, e.g. rates changing during charging session; — consideration of cable losses; — sealing; — bi-directional energy transfer. Electric vehicle supply equipment measuring systems (EVSE-MS) as defined in this document are intended to be used for electric vehicle supply equipment (EVSE) complying such as with IEC 61851-series. This document does not: — cover data communication protocols — specify onboard measuring equipment for rolling stock, according to EN 50463-series and IEC 62888-series The requirements for AC and DC static meters are specified in EN 50470-3:2022 and EN 50470-4:2023. NOTE This document can be used for other metering applications similar to EVSE, as far as applicable, eg. applications for the electrical energy transfer to vessels.

Purpose

Following a TC13 vote (CIV tool : TC13/Sec0191/Q - switch EN 50732 to a TS), previous project prEN50732 with a similar scope has been cancelled due to lack of time. TC13 decided (within same vote) to continue the work within a TS, with an updated scope. Work will start from WD2 of cancelled project prEN50732. It is planned that this TS will be later converted to an EN - especially once MID targeted amendment bringing some requirements for EVSE will be approved.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

03/02/2025

Proposal end date:

26/02/2025

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

NWIP 81265 Electric mobility – Measuring systems for supply equipment

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error