British Standards Institution

Source:: CEN
Committee:: PKW/0 - Packaging
Categories:: Information management | Standardization. General rules

Scope

This data sheet specifies dimensions of glass finish for pouring clip on cap finish (so-called “Verplast “) of diameter 29 and 32 for still liquids (e.g.; oils, cordials, sauces, vinegar, …).

The following finishes are detailed in this data sheet:

- "Verplast" diameter 29/21 for spout with short skirt

- "Verplast" diameter 29/21 K32 for spout with long skirt

- "Verplast" diameter 32/24 for spout with short skirt for plastic caps.

Purpose

This is about defining the ring for snap-on caps intended for certain bottles of oil, vinegar, syrup, and various sauces. It will be based on the Data Sheet made by CETIE.

Note: in case the WI is based on documents from other organizations than ISO/IEC, please specify it here

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

06/01/2025

Proposal end date:

14/01/2025

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

New Work Item Proposal Packaging – Glass finishes for snap-on pourer closures (so-called “Verplast” finishes)

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error