British Standards Institution

Source:: IEC
Committee:: EPL/48 - Electromechanical components and mechanical structures for electronic equipment
Categories:: Information management | Standardization. General rules

Scope

This specification specifies the interface dimensions, technical parameters, performance requirements, and test methods for16-pole wrench locking connectors with 3,5 A rated current and IP65 (in accordance with IEC 60529) plastic housing.

This detail specification is applicable to electrical connectors with a rated voltage up to and including 80 V d.c. and rated current of 3.5 A, in the field of electrical and electronic equipment.

Purpose

a) By the application of this specification, existing various signal connection interface will be integrated, wiring mode will be optimized, the cost of communication industry will be effectively reduced and the international competition ability of communication equipment supplier will be promoted.

b) The product mentioned in this specification has been widely applied in photovoltaic equipment worldwide.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

20/09/2024

Proposal end date:

08/11/2024

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

PNW 48B-3123 ED1 Connectors for electrical and electronic equipment - Product requirements - Part 3-XXX: Rectangular connectors - Detail specification for 16-pole wrench locking connectors with 3,5 A rated current and IP65 plastic housing

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error