British Standards Institution

Source:: IEC
Committee:: GEL/8 - Systems Aspects for Electrical Energy Supply
Categories:: Information management | Standardization. General rules

Scope

This document presents the analysis of the management of active parts and exposed conductive parts towards earth in some defined installations, where the DC section is connected to the AC grid by means of an AC/DC converter with galvanic separation.

Purpose

This document is needed to prepare an analysis of the faults that can happen in the following distributions systems:

1) DC users connected to a public DC distribution grid having a single interface with the AC public grid

2) DC users connected to a public DC distribution grid having multiple interfaces with AC public grid

3) DC users connected to a public low voltage AC distribution grid by means of the users’ AC/DC conversion system

Fault analysis is the basis to guarantee the safety of electrical installations

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

17/04/2024

Proposal end date:

30/05/2024

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

PNW TS SYCLVDC-150 ED1 Management of active parts and exposed conductive parts with isolated converters

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error