British Standards Institution

Source:: IEC
Committee:: CPL/116 - Safety of motor-operated electric tools
Categories:: Information management | Standardization. General rules

Scope

This part of IEC 63241 applies to jointers.

Purpose

There is a need to develop and publish international standards to harmonize the test methods for measuring dust created by electric motor-operated tools during their operation. This standard would be based on the existing EN 50632 series of standards.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

28/02/2024

Proposal end date:

22/04/2024

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

PNW 116-741 ED1: Electric motor-operated tools - Dust measurement procedure - Part 2-19: Particular requirements for hand-held jointers

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error