British Standards Institution

Source:: CEN
Committee:: PVE/19 - LPG containers and their associated fittings
Categories:: Information management | Standardization. General rules

Scope

This European Standard specifies the minimum requirements for the material, design, construction, workmanship, equipping, inspection and testing at manufacture of transportable, refillable welded steel pressure drums of volumes over 150 l up to and including 1 000 l for Liquefied Petroleum Gases (LPG).

Vertical and horizontal cylindrical receptacles are covered.

Purpose

Considering the need for PRV requirements for Drums, considering that CEN/CT 286 does not currently address PRV requirements for Drums, considering the possible location for this requirement, EN 14129, EN 14893, EN 13953, EN 14570, considering discussion had at 37th Plenary meeting, considering WG7, WG 2, WG 1 recommendation, Decision 07/2021 was taken by the technical committee at the 37th Plenary to revise EN 14893:2014 for the inclusion of a new informative annex on the sizing of the relief valves for pressure drums.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

02/01/2024

Proposal end date:

06/02/2024

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

Revision of EN 14893, LPG equipment and accessories - Transportable LPG welded steel pressure drums with a capacity between 150 litres and 1 000 litres

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error