British Standards Institution

Source:: CEN
Committee:: AUE/0/-/1 - Circular and sustainable materials for road vehicles
Categories:: Information management | Standardization. General rules | Environment | Environmental protection | Road vehicles engineering | Plastics

Scope

This document specifies recommendations for the design of plastic products used in road vehicles to facilitate separation and recycling after shredding.

Purpose

Recyclability of vehicles needs being improved to achieve the use of 10 million ton recycled plastics in products by 2025 Circular Plastics Alliance. In other words, automotive plastic products should be designed in a friendly way to current recycling technologies. Post Shredder Technology is currently the most common used technology for recycling of used automotive plastic products. Therefore, it is essential for European automotive industry to develop best practices to design automotive products to facilitate Post Shredder Technology recycling. Note: in case the WI is based on documents from other organizations than ISO/IEC, please specify it here

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: admin.start@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

21/04/2022

Proposal end date:

30/05/2022

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

CEN/TC 301 N 863, Consultation to adopt a Preliminary Work Item for a CEN/TS - Road vehicles - Post Shredder Technology recycling - Design recommendations for plastic products

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error