British Standards Institution

Source:: CEN
Committee:: MHE/3/1 - Crane design
Categories:: Information management | Standardization. General rules | Engineering | Materials handling equipment | Lifting equipment | Cranes

Scope

This document specifies an interface of a crane duty (loads, loads cycles) and its following elements:

- cylindrical gears, helical and spur and bevel gears, in open gear transmissions or enclosed in gear boxes

- gear boxes with their bearings and shafts

Purpose

Gears and gear boxes are essential load carrying elements in cranes. To date there is no European standards on gear boxes in cranes or how to apply the general gear calculation ISO standards to cranes.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

15/09/2021

Proposal end date:

21/10/2021

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

CEN/TC 147 N 1331, EN 13001-3-7 Cranes — General design — Part 3-7: Limit states and proof of competence of machinery – Gears and gear boxes

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error