British Standards Institution

Source:: CEN
Committee:: FSH/18/6 - Gaseous Extinguishing Media and Systems
Categories:: Information management | Standardization. General rules | Health and Safety | Fire Protection | Fire-fighting | Fire protection equipment

Scope

This European Standard specifies requirements and describes test methods for check and non-return valves intended to be used in gas extinguishing systems (i.e. CO2, Inert Gas or Halocarbon gas) installed in buildings as a part of a complete operating system. This European Standard is applicable to check valves installed between container valve and manifold and non-return valves installed in pilot lines, except those valves which are tested in combination with non-electrical control devices.

Purpose

Revision and adaption of the standard according to the new Construction Products Regulation

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

17/08/2021

Proposal end date:

25/09/2021

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

CEN/TC 191 N 1883, Revision of EN 12094-13 2001 Fixed firefighting systems - Components for gas extinguishing systems - Part 13: Requirements and test methods for check valves and non-return valves

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error