British Standards Institution

Source:: CEN
Committee:: NFE/34 - Copper and copper alloys
Categories:: Information management | Standardization. General rules | Engineering | Electrical engineering | Wires | Manufacturing | Metallurgy | Copper. Copper alloys

Scope

This European Standard specifies the composition, property requirements and dimensional tolerances for copper alloy wire, finally produced by drawing, rolling or extruding, intended for general purposes, spring and fastener manufacturing applications. The sampling procedures and the methods of test for verification of conformity to the requirements of this European Standard are also specified.

Purpose

Revision of the Standard to introduce the acceptance criteria for eddy current test and Annex ZA.

Modification of chemical composition of certain copper-zinc-lead alloys to follow the trend to reduce lead content (Reach, DWD, RoHS,…).

Revision of the Standard to introduce the acceptance criteria for eddy current test and Annex ZA.

Modification of chemical composition of certain copper-zinc-lead alloys to follow the trend to reduce lead content (Reach, DWD, RoHS,…).

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

02/07/2021

Proposal end date:

01/08/2021

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

CEN/TC 133 N2620 Draft Decision 06/2021 Copper and copper alloys - Wire for general purposes

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error