British Standards Institution

Source:: CEN
Committee:: ISE/105 - Steels for Heat Treatment, Alloy Steels, Free-Cutting Steels and Stainless Steels
Categories:: Information management | Standardization. General rules | Engineering | Manufacturing | Metallurgy | Steels | Iron and steel products | Iron and steel products. General | Steels. Heat-treatable | Steels. Stainless

Scope

This European standard applies to bright steel products in the drawn, turned or ground condition delivered in straight lengths. It does not cover cold rolled products and cut lengths produced from strip or sheet by cutting.

This standard, first issued in 1999 and never modified, was referred specifically to the first issue of EN 10277 (in five parts), as the sequential numbering clearly shows. It was applicable also to other steel types, and in particular to bright products in stainless according to EN 10088-3.

When EN 10277 was revised in 2018, following the scheme of ISO 683-18:2014, the tolerances of bright products for the steels of this standard were completely included in EN 10277.

As a consequence, EN 10278 should not include all the products already included in EN 10277:2018..

Purpose

New Item Work Proposal

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

30/10/2020

Proposal end date:

16/11/2020

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

CEN/TC 459/SC 5 N 246, Revision of EN 10278, Dimensions and tolerances of bright steel products

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error