British Standards Institution

Source:: ISO
Committee:: STI/1 - (Disbanded 01.11.2022 See W/-) Pigments
Categories:: Information management | Vocabularies | Rubber and plastics industries | Paint and colour industries | Standardization. General rules | Manufacturing | Paint and colour industries | Paint ingredients | Pigments and extenders

Scope

This part of the standard series describes a method for determining the colour stability of colouring materials under defined conditions in plastics by injection moulding. The result of the determination is a relative value, not an absolut one. The method is applicable for testing colouring materials in thermoplastics that are processible by injection moulding..

Purpose

There is a need to have this standards at International level.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

10/02/2020

Proposal end date:

26/03/2020

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

ISO/NP 25877-2 Colouring materials in plastics — Determination of colour stability to heat during processing of colouring materials in plastics — Part 2: Determination by injection moulding – ISO/TC 256 N570

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error