British Standards Institution

Source:: ISO
Committee:: CH/173/1 - Wheelchairs
Categories:: Information management | Standardization. General rules | Measurement and Science | Testing | Testing. Electrical and electronic | Healthcare | Aids. Disabled persons | Aids. Disabled persons. General | Aids. Adaptation for moving | Electrical engineering | Cells and batteries

Scope

This International Standard specifies requirements and test methods for lead-acid batteries and their chargers intended for use with electrically powered wheelchairs. Requirements for chargers are applicable to those with a rated input voltage not greater than 250 V a.c. and a nominal output voltage not greater than 36 V.

Purpose

This standard covers batteries and their chargers for powered wheelchairs in general. With the introduction of Lithium ion batteries for use in wheelchairs there needs to be a differentiation between these 2 chemistries. The standard for lithium-ion batteries for wheelchairs is currently under development. Furthermore changes to cyclic endurance and charge retention have made these criteria more meaningful.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

06/08/2019

Proposal end date:

16/08/2019

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

ISO/NP 24600-25,- ISO/TC 173/SC 1 N 905 Wheelchairs- -- Part 25: Part25: Batteries and chargers for powered wheelchairs -- Requirements and test methods

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error