British Standards Institution

Source:: CEN
Committee:: B/505 - Wastewater engineering
Categories:: Information management | Standardization. General rules | Construction | Construction materials and building | Construction industry | Construction industry. General | Buildings | Buildings. General

Scope

This European Standard classifies floor gullies for use inside buildings, gives guidance for places of installation and specifies requirements for the construction, design, performance and marking of factory made gullies for buildings, irrespective of the material, for use in drainage systems requiring a trap with combined mechanical closure and water seal (referred to as floor gullies). Note: Floor gullies with combined mechanical closure and water seal are not covered by Part 1, Part 6, Part 7.

These products are intended to be installed where:

- the building does not exceed a ground-floor and three floors above.

Purpose

Addition to the standard series EN 1253 "Gullies for buildings of a Part 8 on "Trapped floor gullies with combined mechanical closure and water seal" in accordance with the work program of CEN/TC 165.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

31/07/2019

Proposal end date:

30/08/2019

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

CEN/TC 165 N 3195 , EN 1253-8 Gullies for buildings - Part 8: Trapped floor gullies with combined mechanical closure and water seal

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error