British Standards Institution

Source:: ISO
Committee:: AUE/16 - Data Communication (Road Vehicles)
Categories:: Road vehicle engineering | Standardization. General rules | Engineering | Road vehicles engineering | Road vehicle systems | Road vehicle systems. General | Indicating and control devices

Scope

This document describes the calibration procedure of displacement devices. The calibration is carried out with the sensor disassembled from the dummy. The procedure is for sensors with analogue as well as digital output. The displacement calibration is running according the classic calibration method for standard displacement devices like Dial gauges. This means that the calibration is carried out with a rising and falling ramp over the measuring range for the determination of non-linearity and hysteresis. In addition, the repeatability precision is determined at a measuring point that is approached from one direction.

Purpose

The specification of a uniform procedure for the calibration of displacement devices will produce more comparable calibration results

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal

Proposal start date:

05/06/2019

Proposal end date:

20/06/2019

2. Draft

3. Public Comments

4. Comment Resolution

5. Approval

6. Publication

Learn more about the standards development process

Standards Development

ISO/NP TS 23521 - ISO/TC 22 N 3889 Road vehicles -- Calibration procedure for displacement devices

Scope

Purpose

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error