British Standards Institution

Source:: CEN
Committee:: PRI/0 - Plastics and rubber standards and terminology
Categories:: Plastics. General
Comment period start date:: 29/10/2026
Comment period end date:: 04/01/2027
Number of comments:: 0

Comment by:

4th Jan

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: admin.start@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

07/08/2026

3. Public Comments

Public Comments start date:

29/10/2026

Public Comments end date:

04/01/2027

Learn more about the standards development process

Standards Development

BS EN ISO 11359-2 EN ISO 11359-2 Plastics. Thermomechanical analysis (TMA). Part 2: Determination of coefficient of linear thermal expansion and glass transition temperature (ISO 11359-2:2021)

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error