Standards Development
This document specifies the minimum requirements for verification of the torque and angle output of hand torque tools used for controlled tightening of screws and nuts.
This document applies to hand torque tools which are classified as indicating torque tools (Type I) and setting torque tools (Type II).
NOTE Hand torque tools covered by this document include those identified in ISO 1703:2018 by reference numbers 6 1 00 11 0, 6 1 00 11 1 and 6 1 00 12 0, 6 1 00 12 1 and 6 1 00 14 0, 6 1 00 15 0. Tools not yet included in the above edition will be included upon the next revision.
This document does not specify requirements of calibration certificates for hand torque tools. These are described in ISO 6789-2.
Required form fields are indicated by an asterisk (*) character.
You are now following this standard. Weekly digest emails will be sent to update you on the following activities:
You can manage your follow preferences from your Account. Please check your mailbox junk folder if you don't receive the weekly email.
You have successfully unsubscribed from weekly updates for this standard.
Comment by: