British Standards Institution

Source:: IEC
Committee:: GEL/86/1 - Optical fibres and cables
Categories:: Fibres and cables
Number of comments:: 0

Scope

This part of IEC 60794-1 describes test procedures to be used in establishing uniform requirements for optical fibre cables primarily for OPGW, OPPC, OPAC and ADSS for the mechanical property – Sheave test. The purpose of this test is to determine the ability of these cables to withstand bending around sheaves or bows during installation, when a specified load is applied.

This document applies to optical fibre cables for use with telecommunication equipment and devices employing similar techniques, and to cables having a combination of both optical fibres and electrical conductors.

See IEC 60794-1-2 for a reference guide to test methods of all types and for general requirements.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

04/10/2024

3. Public Comments

Public Comments start date:

19/04/2024

Public Comments end date:

05/06/2024

Learn more about the standards development process

Standards Development

BS IEC 60794-1-135 ED1 BS EN 60794-1-135 ED1 Optical fibre cables -. Part 1-135: Generic specification - Basic optical cable test procedures - Mechanical tests methods - Sheave test, Method E35

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error