British Standards Institution

Source:: ISO
Committee:: PRI/10 - Terminology for rubbers and plastics
Categories:: Rubber and plastics industries | Latex and raw rubber | Rubber
Comment period start date:: 03/06/2024
Comment period end date:: 27/07/2024
Number of comments:: 0

Comment by:

27th Jul

Scope

This International Standard establishes a system of symbols for the basic rubbers in both dry and latex forms, based on the chemical composition of the polymer chain.

The purpose of this International Standard is to standardize the abbreviated terms used in industry, commerce, and government, and it is not intended to conflict with, but rather to act as a supplement to, existing trade names and trademarks.

NOTE 1 It is intended that in technical papers or presentations, the name of the rubber be used, if possible. It is intended that the symbols follow the chemical name for use in later references.

NOTE 2 The nomenclature of thermoplastic elastomers is described in ISO 18064[1].

Read draft and comment

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

02/04/2024

3. Public Comments

Public Comments start date:

03/06/2024

Public Comments end date:

27/07/2024

Learn more about the standards development process

Standards Development

BS ISO 1629 ISO 1629 Rubber and latices. Nomenclature

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error