British Standards Institution

Source:: IEC
Committee:: PEL/85 - Measuring equipment for electrical and electromagnetic quantities
Categories:: Measurement. Electrical and magnetic quantities
Number of comments:: 1

Scope

This document provides a classification of NILM sensing devices for use in NILM systems, according to the state of the art of NILM technologies.

The classification of NILM analytics and NILM systems, as well as performance indicators for NILM systems, can be considered in the future.

NILM systems produce estimated disaggregation into energy usages. When accurate measurement and analysis of energy consumption and/or other electrical parameters is needed (e.g. for monitoring the electrical installation), systems based on standardized measuring devices (e.g. PMD, PQI or meters) are used.

NOTE Standardized measuring devices have guaranteed accuracy over a specified range and have limited deviations in presence of influence quantities (temperature, frequency deviations…) in addition to safety and constructional requirements. See Annex C for more information.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

19/07/2024

3. Public Comments

Public Comments start date:

20/02/2024

Public Comments end date:

03/04/2024

Learn more about the standards development process

Standards Development

BS EN IEC 63297 ED1 BS EN 63297 ED1 Sensing devices for non-intrusive load monitoring (NILM) systems

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error