British Standards Institution

Source:: ISO
Committee:: PSE/17/-/3 - Drilling and completion fluids and well cements
Categories:: Lubricants, industrial oils and related products
Number of comments:: 6

Scope

This document provides standard test procedures for evaluating coated proppants used in hydraulic fracturing operation.

Note that ISO 13503-8 is only available for evaluating the effectiveness of coated proppants. For sieve analysis, mean diameter, roundness, sphericity, turbidity, acid solubility, bulk density, absolute density, proppant crush-resistance, and loss on ignition of resin-coated proppant, please refer to ISO 13503-2, and conductivity of proppants, refer to ISO 13503-5.

The purpose of ISO 13503-8 is to provide a consistent methodology for tests performed on coated proppants used in hydraulic fracturing operation.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

29/11/2023

3. Public Comments

Public Comments start date:

20/05/2024

Public Comments end date:

13/07/2024

Learn more about the standards development process

Standards Development

BS EN ISO 13503-8 Oil and gas industries including lower carbon energy — Completion fluids and materials —. Part 8: Measurement of properties of coated proppants used in hydraulic fracturing

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error