British Standards Institution

Source:: ISO
Committee:: MCE/12 - Plain bearings
Categories:: Bearings. Plain
Comment period start date:: 21/10/2024
Comment period end date:: 14/12/2024
Number of comments:: 0

Comment by:

14th Dec

Scope

This document specifies requirements for multilayer materials for the manufacture of thin-walled plain bearings (half bearings, bushes, thrust washers). The multilayer material consists of a steel backing, the bearing layer (cast, sintered, roll bonded) and, possibly, an overlay. The chemical composition refers to the original unprocessed material and is intended to be measured using representative samples. Testing results on final bearings can be different due to the influence of bearing production. Therefore, these results cannot be compared with data given in this document.

Read draft and comment

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

19/10/2023

3. Public Comments

Public Comments start date:

21/10/2024

Public Comments end date:

14/12/2024

Learn more about the standards development process

Standards Development

BS ISO 4383 Plain bearings — Multilayer materials for thin-walled plain bearings

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error