British Standards Institution

Source:: ISO
Committee:: FME/9 - Fasteners
Categories:: Screw threads. Metric
Comment period start date:: 26/09/2024
Comment period end date:: 19/11/2024
Number of comments:: 0

Comment by:

19th Nov

Scope

This document specifies the limits of sizes for major, pitch and minor diameters of ISO general purpose metric screw threads (M) conforming to ISO 261 having basic and design profiles in accordance with ISO 68-1.

This document is applicable to the metric fastening screw threads with the ten recommended tolerance classes specified in ISO 965-1.

Please see draft for Table 1 — The guide for M screw threads with the ten recommended tolerance classes

Read draft and comment

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

21/06/2024

3. Public Comments

Public Comments start date:

26/09/2024

Public Comments end date:

19/11/2024

Learn more about the standards development process

Standards Development

BS ISO 965-6 ISO 965-6 ISO general purpose metric screw threads. Tolerances. Part 6: Limits of sizes for internal and external threads (Fine and medium tolerance qualities, first and second choices)

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error