British Standards Institution

Source:: ISO
Committee:: MCE/7 - Rolling bearings
Categories:: | Bearings. Rolling
Number of comments:: 0

Scope

This document specifies the chamfer least material boundary for ring and washer chamfers of metric series rolling bearings for the corresponding radius maximum material boundaries. The radius maximum material boundaries are given in other documents.

Recommendations are given for the corresponding shaft and housing fillet radii.

This document does not apply to ring or washer chamfers which are specified in other documents.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

15/10/2024

3. Public Comments

Public Comments start date:

17/12/2024

Public Comments end date:

09/02/2025

Learn more about the standards development process

Standards Development

BS ISO 582 Rolling Bearings — Chamfer dimensions — Geometrical product specification (GPS) and values

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error