British Standards Institution

Source:: ISO
Committee:: ISE/101/5 - Indentation hardness testing
Categories:: Testing. Mechanical | Metal testing. Mechanical
Number of comments:: 0

Scope

This part of ISO 14577 specifies the method of verification and calibration of testing machines for carrying out the instrumented indentation test in accordance with ISO 14577‑1.

It describes a direct verification method for checking the main functions of the testing machine and an indirect verification method suitable for the determination of the repeatability of the testing machine. There is a requirement that the indirect method be used in addition to the direct method and for the periodic routine checking of the testing machine in service.

It is a requirement that the indirect method of verification of the testing machine be carried out independently for each test method.

This part of ISO 14577 is also applicable for transportable testing machines.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

02/10/2023

3. Public Comments

Public Comments start date:

02/08/2024

Public Comments end date:

25/09/2024

Learn more about the standards development process

Standards Development

BS EN ISO 14577-2 Metallic materials — Instrumented indentation test for hardness and materials parameters —. Part 2: Verification and calibration of testing machines

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error