British Standards Institution

Source:: IEC
Committee:: PEL/11 - Overhead Lines
Categories:: Power transmission and distribution lines
Number of comments:: 0

Scope

This International Standard applies to fittings for overhead lines of nominal voltage above 45 kV. Fittings concerned particularly are all fittings except those that have a specific standard dedicated like spacers (IEC 61854), dampers (IEC 61897) and end fittings for insulators (IEC 61466-1). It may also be applied to fittings for overhead lines of lower nominal voltage and to similar fittings for substations. Moreover, fittings designed for use with High Temperature (HT) conductors are included.In some cases, test procedures and test values are left to agreement between purchaser and supplier and are stated in the procurement contract. The purchaser is best able to evaluate the intended service conditions, which should be the basis for establishing the test severity.In Annex A, the minimum technical details to be agreed between purchaser and supplier are listed.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

10/09/2021

3. Public Comments

Public Comments start date:

25/03/2021

Public Comments end date:

12/05/2021

Learn more about the standards development process

Standards Development

BS EN IEC 61284 Overhead lines - Requirements and tests for fittings

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error