British Standards Institution

Source:: IEC
Committee:: PEL/22 - Power electronics
Categories:: Switchgear and controlgear. General | Motors | Rectifiers. Converters. Stabilized power supply
Number of comments:: 0

Scope

This part of IEC 61800 specifies the general methodology to energy efficiency standardization for any extended product by using the guidance of the extended product approach (EPA).

It enables product committees for driven equipment connected to motor systems (so called extended products) to interface with the relative power losses of the connected motor system (e.g. power drive system) in order to calculate the system energy efficiency for the whole application.

This is based on specified calculation models for speed/load profiles, the duty profiles and relative power losses of appropriate torque versus speed operating points.

This document specifies the methodology of determination of losses of the extended product and its sub-parts.T

his document is applicable to motor systems operated by a motor starter or by a converter (power drive systems).

This document does not specify requirements for environmental impact declarations.

Comment on proposal

Required form fields are indicated by an asterisk (*) character.

How important do you think standardization is in this area? *

Do you agree that a standard on this subject is feasible?: *

Please give reasons for your selections above: *

Would you or your organization use the standard? *

Would you or your organization be prepared to participate in the development of the standard or to comment on the draft when it is available? *

Are you aware of any regulation, existing standards and other good practice information in this area in the UK (e.g. Industry codes of practice; company specifications, international or European Standards)? *

Would the development of a standard(s) in this area have a particular impact/relevance to SME, consumer, environmental or societal interests? *

Are you aware of any other organizations to which this proposal may be relevant? If so please provide details below. *

Additional comments on the scope or proposal:

Although BSI will not usually enter into correspondence regarding individual comments or suggestions we may wish to contact you to seek further clarification. Please indicate whether this will be acceptable: *

Discard

Please email further comments to: debbie.stead@bsigroup.com

Standard timeline

1. Proposal (Complete)

Proposal start date:

2. Draft (Complete)

Draft start date:

27/11/2017

3. Public Comments

Public Comments start date:

25/07/2019

Public Comments end date:

14/10/2020

Learn more about the standards development process

Standards Development

Scope

Comment on proposal

Discard changes?

Submit comment

Submit comment

Follow standard

Unfollow standard

Error